Casting the seals of the inspection ports on two of the bulkheads. The seals are made of a polyurethane elastomer. The yoghurt tubs are used to provide an accurate tapering sealing surface.
posted by Niel Malan @ 09:02
Tuesday, December 20, 2005
Casting the seals of the inspection ports on two of the bulkheads. The seals are made of a polyurethane elastomer. The yoghurt tubs are used to provide an accurate tapering sealing surface.
I am building the Argie 10 sailing dinghy. Its a simple design suitable for beginners.
Previous Posts
- Gluing in the mast collars on the model. This is ...
- Sticky job: all the inside seams fibreglassed wit...
- Finished with the tying. The hull now has its sha...
- Tied up: Copper wire ties on all the seams.
- Eight sheafs of ten each: eighty ties ready for t...
- Glueing in the mast step (invisible under the cla...
- The side panels are now loosely attached, and the...
- The side panels loosely joined with copper wire s...
- Tighten the stiches, and the bottom becomes grace...
- The panels now have the copper wire stiches put i...
0 Comments:
Post a Comment
<< Home