BoatBlog

Tuesday, December 20, 2005

A completed inspection port seal. This side will be on the 'inside' i.e. inside the floatation compartment.

posted by Niel Malan @ 09:05

I am building the Argie 10 sailing dinghy. Its a simple design suitable for beginners.

Previous Posts

• Casting the seals of the inspection ports on two ...
• Gluing in the mast collars on the model. This is ...
• Sticky job: all the inside seams fibreglassed wit...
• Finished with the tying. The hull now has its sha...
• Tied up: Copper wire ties on all the seams.
• Eight sheafs of ten each: eighty ties ready for t...
• Glueing in the mast step (invisible under the cla...
• The side panels are now loosely attached, and the...
• The side panels loosely joined with copper wire s...
• Tighten the stiches, and the bottom becomes grace...